PVC Cat Walker

Use PVC pipe to construct a walker for your cat! Cut eight pieces of PVC pipe to make two rectangles and cut two additional pieces for the side rails of the walker. Assemble each of the rectangles with PVC elbow connectors on either top corner and PVC T-shape connectors on either bottom corner. Attach the rails to either side of the rectangles with T-connectors. Put caster inserts in the open end of each T-connector on the bottom corners of the walker, then attach the rolling casters to the inserts. Measure your pet, cut a hole in a hand towel at the location needed for each of your cats legs, lay the towel over the side rails and sew either end of the towel into a tube shape around each of the rails. Drill holes through each connector joint and secure the joints with screws.